New transmission

When you supercharge a car or add more power then it comes with you should look into getting a new transmision, and make sure it can handle the power from your motor, also think about buying a new stronger drive shaft. To install the transmission you will have to jack up your car. Their should be eight bolts connecting it to your enging along with u-joints on either side of your drive shaft, you will pull all the codder pins on both u-joints then pull the pin out. once you have pulled the pin out you can remove the drive shaft from your car. Now you can drop your tranny out once you have inbolted the eight bolts. Their will be tranny fluid let it drain, then their should be a driveline hooked up to your cams. Un-bolt the drive line from the camshart, this will allow your whole tranny asssembly to drop out of your car but before you do that make sure to un bolt your shifter, unless you are putting a new shifter into the car. Once you have done that you can install the new tranny hook everything back up, but dont worry about the tranny fluid to the end. Now that your tranny is back in be sure when you install the new drive  shaft to replace the u-joints with the newely required u-joints, or you will have problems with them. Once you have the new drive shaft in connect your shifter, and pour the requirred amount of tranny fluid into the resevoure. After that is done be sure to take it easy for a while untill the tranny fluid has been completely ran throught the system. Once you have everything done you should take your car to a shop so they can tune it for your tranny and engine requirements.