Gauges

To install gauges you will need to order the gaudge pod, gauges, wiring, and gauge reader modules.
First things first install the gauge pod into the desired spot on the dash, or pillar in our interior. Once you have installed the pod you can start putting your gauges in, after you have this done run all the wires from the gauge into the engine compartment. After you have this complete splice all wires and hook them up to coresponding reader modules. Once each reader is hooked up it is time to insert them into the proper engine compenents. For the air to fuel modual you will plug that into your mass air flow sensor, their should be a sensor in there with a slot for a plug in all you have to do then is plug it in. For the boost gauge you will have to find the correct plug in on your supercharger and insert it usually its where the plug from the computer plugs into also. After that one is done you should plug in your RPM gauge which plugs right into your fuse box, to find where you should read the fuse index on the cover of fuse box. Once they are all hooked up link all the gauges into one power wire and run it to a constant power source. Ground the negative and you should have working gauges.